SH2D500WE230 Carlo Gavazzi

SH2D500WE230, Dimmer up to 500 W with power reading Model SH2D500WE230., SH2D500WE230, This 500 W universal dimmer is designed for DIN rail mounting with energy measurement. Single-phase variables: Wdmd, W, VA, VAr, A, VLN, PF. Energy measurement: total kWh consumed by the connected load. This universal dimmer is suitable for the regulation of resistive, inductive and capacitive loads, as well as LED lamps (see table of LED lamps). The maximum load of type R, L and C is 500 W depending on the temperature; the reduction is described according to the trend of the "reduction curve" diagram. The dimmer automatically detects whether the connected load is resistive, capacitive or inductive, but in the case of an LED lamp, the user must select the appropriate curve as described below. The dimmer is fully programmable through the smart-house tool. The technology used allows to electrically protect the dimmer against short circuits, overload and overtemperature. Thanks to the internal bus, it can be easily connected to other adjacent dimmers (see the "connection diagram") without the need to wire the Bus Dupline®. In addition, the integrated heat sink allows to install adjacent dimmers without reducing the load due to the increase in temperature., SH2D500WE230, Operating Mode If the SH2D500WE230 is connected to the Dupline bus® and the bus works properly, the dimmer will be in STANDARD mode and the green LED will be activated. The dimmer accesses the LOCAL mode if the button is pressed or if there is a bus failure or is not connected. In LOCAL mode, the dimmer does not support any bus commands and the LED will flash. The dimmer can return to STANDARD mode only when.