RUT900 TELTONIKA

RUT900 TELTONIKA, MOBILE Mobile module 3G – Up to 14.4 Mbps, 2G – Up to 236.8 kbps, SIM switch 2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection, Status Signal strength (RSSI), EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID, SMS SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP, Black/White list Operator black/white list, Band management Band lock, Used band status display, APN Auto APN, Bridge Direct connection (bridge) between mobile ISP and device on LAN, Passthrough Router assigns its mobile WAN IP address to another device on LAN, WIRELESS Wireless mode IEEE 802.11b/g/n, Access Point (AP), Station (STA), WiFi security WPA2-Enterprise - PEAP, WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation, SSID SSID stealth mode and access control based on MAC address, WiFi users Up to 100 simultaneous connections, Wireless Hotspot Captive portal (Hotspot), internal/external Radius server, built in customizable landing page, ETHERNET WAN 1 x WAN port (can be configured to LAN) 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX, LAN 3 x LAN ports, 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX, NETWORK Routing Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2), Network protocols TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SNMP, MQTT, Wake On Lan (WOL), VoIP passthrough support H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets, Connection monitoring Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection, Firewall Port forward, traffic rules, custom rules, DHCP Static and dynamic IP allocation, DHCP Relayd, QoS Traffic priority queuing by source/destination, service, protocol or port, traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e, DDNS Supported >25 service providers, others can be configured manually, Network backup VRRP, Mobile, Wired and WiFi WAN options, each of which can be used as backup, using automatic Failover, Load balancing Balance your internet traffic over multiple WAN connections, SSHFS (optional) Possibility to mount remote file system via SSH protocol (not available in standard FW), SECURITY Authentication Pre-shared key, digital certificates, X.509 certificates, Firewall Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T, Attack prevention DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention ( SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks), VLAN Port and tag based VLAN separation, Mobile quota control Set up custom data limits for both SIM cards, WEB filter Blacklist for blocking out unwanted websites, whitelist for specifying allowed sites only, Access control Flexible access control of TCP, UDP, ICMP packets, MAC address filter, VPN OpenVPN Multiple clients and server can be running simultaneously, 12 encryption methods, OpenVPN Encryption DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC, IPsec IKEv1, IKEv2, supports up to 4 x VPN IPsec tunnels (instances), with 5 encryption methods (DES, 3DES, AES128, AES192, AES256), GRE GRE tunnel, PPTP, L2TP Client/Server services can run simultaneously, Stunnel Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the programs' code, SSTP SSTP client instance support, ZeroTier ZeroTier VPN, WireGuard WireGuard VPN client and server support, MODBUS MODBUS TCP SLAVE ID filtering Respond to one ID in range [1;255] or any, Allow Remote Access Allow access through WAN, Custom registers Modbus TCP custom register block requests, which read/write to a file inside the router, and can be used to extend Modbus TCP Slave functionality, MODBUS TCP MASTER Supported functions 01, 02, 03, 04, 05, 06, 15, 16, Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), MODBUS DATA TO SERVER Protocol HTTP(S), MQTT, Azure MQTT, MQTT GATEWAY MQTT gateway Allows sending commands and receiving data from Modbus Master through MQTT broker, MONITORING & MANAGEMENT WEB UI HTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, event log, system log, kernel log, FOTA Firmware update from server, automatic notification, SSH SSH (v1, v2), SMS SMS status, SMS configuration, send/read SMS via HTTP POST/GET, Call Reboot, Status, WiFi on/off, Mobile data on/off, Output on/off, TR-069 OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem, MQTT MQTT Broker, MQTT publisher, SNMP SNMP (v1, v2, v3), SNMP trap, JSON-RPC Management API over HTTP/HTTPS, MODBUS MODBUS TCP status/control, RMS Teltonika Remote Management System (RMS), SYSTEM CHARACTERISTICS CPU Atheros Wasp, MIPS 74Kc, 550 MHz, RAM 128 MB, DDR2, FLASH storage 16 MB, SPI Flash, FIRMWARE / CONFIGURATION WEB UI Update FW from file, check FW on server, configuration profiles, configuration backup, restore point, FOTA Update FW/configuration from server, RMS Update FW/configuration for multiple devices, Keep settings Update FW without losing current configuration, FIRMWARE CUSTOMIZATION Operating system RutOS (OpenWrt based Linux OS), Supported languages Busybox shell, Lua, C, C++, Development tools SDK package with build environment provided, INPUT/OUTPUT Input 1 x Digital input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high, Output 1 x Digital open collector output, max output 30 V, 300 mA, Events SMS, EMAIL, RMS, POWER Connector 4 pin industrial DC power socket, Input voltage range 9 – 30 VDC, reverse polarity protection; surge protection >31VDC 10us max, PoE (passive) Passive PoE over spare pairs. Possibility to power up through LAN port, not compatible with IEEE802.3af, 802.3at and 802.3bt standards, Power consumption u003C 2 W idle, u003C 7 W Max, PHYSICAL INTERFACES (PORTS, LEDS, ANTENNAS, BUTTONS, SIM) Ethernet 4 x RJ45 ports, 10/100 Mbps, I/O’s 1 x Digital Input, 1 x Digital Output on 4 pin power connector (available from HW revision 1600), Status LEDs 1 x bi-color Connection type status LED, 5 x Connection strength LEDs, 4 x LAN status LEDs, 1 x Power LED, SIM 2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders, eSIM (Optional), Power 1 x 4 pin DC connector, Antennas 2 x SMA for 3G, 2 x RP-SMA for WiFi antenna connectors, Reset Reboot/Factory reset button, PHYSICAL SPECIFICATION Casing material Aluminium housing, plastic panels, Dimensions (W x H x D) 110 x 50 x 100 mm, Weight 280 g, Mounting options DIN rail (can be mounted on two sides), flat surface placement, OPERATING ENVIRONMENT Operating temperature -40 °C to 75 °C, Operating humidity 10% to 90% non-condensing, Ingress Protection Rating IP30, REGULATORY & TYPE APPROVALS Regulatory CE/RED, EAC, RoHS, WEEE, EMI IMMUNITY Standards Draft EN 303 446-1 V1.1.0, ESD EN61000-4-2:2009, RS EN 61000-4-3:2006 + A1:2008 + A2:2010, EFT EN 61000-4-4:2004, Surge protection EN 61000-4-5:2006, CS EN 61000-4-6:2009, DIP EN 61000-4-11:2004, RF Standards EN 300 328 V2.1.1, EN 301 511 V12.5.1, EN 301 908-1 V11.1.1, EN 301 908-2 V11.1.1, SAFETY Standards IEC 60950-1:2005 (Second Edition) + Am 1:2009 + Am 2:2013nEN 62311:2008, , RUT900 TELTONIKA