S1430UAP912 Carlo Gavazzi

S1430UAP912, Photocells Amplifier, Microprocessor Controlled Model S 1430, 3 Inputs/3 Outputs,, S1430UAP912, Microprocessor controlled amplifier relay for photocells: MOFTR, MKFTR, MIFTR or MHFTR. Undecal plug-in module with 3 outputs selectable for NPN/PNP or NA/NC. Self-diagnosis of the system. Protected against short circuits, polarity reversal, or interference from nearby photocells. Multi-voltage power supply. Adjustable sensitivity for 3 signals., S1430UAP912, Transmitter test (Pin 5 in top position) In this position the yellow and red LEDs on the front will flash simultaneously. When the test is completed (approx. 3 scans) and a wiring failure, such as polarity reversal, or short circuit, is detected, the transmitter that has the failure condition will be indicated with the continuous ON status of the red LED. If there is no fault, the yellow LED will be on ON. If there is a fault, correct it and repeat the test. Always reset pin 5 when the test has concluded to return to normal operation. Receiver test (Pin 6 in top position) In this position the yellow and red LEDs on the front will flash simultaneously. When the test is completed (approx. 3 scans) and a wiring failure, such as polarity reversal, or short circuit, is detected, the transmitter that has the failure condition will be indicated with the continuous ON status of the red LED. If there is no fault, the yellow LED will be on ON. If there is a fault, correct it and repeat the test. Always reset pin 6 when the test has concluded to return to normal operation