TRB145 TELTONIKA

TRB145 TELTONIKA, MOBILE Mobile module 4G (LTE) – Cat 1 up to 10 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps, Bridge Direct connection (bridge) between mobile ISP and device on LAN, Status Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP Bytes sent/received, SMS/Call SMS status, SMS configuration, Call utilities, NETWORK Network protocols TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, SSL v3, TLS, PPP, SSH, DHCP, SNMP, MQTT, Connection monitoring Ping Reboot, Periodic Reboot, LCP and ICMP for link inspection, Wget, Routing Static routing, Firewall Port forwards, traffic rules, custom rules, DHCP Static and dynamic IP allocation, QoS / Smart Queue Management (SQM) (planned) Traffic priority queuing by source/destination, service, protocol or port, DDNS Supported >25 service providers, others can be configured manually, SECURITY Authentication Pre-shared key, digital certificates, X.509 certificates, Firewall Pre-configured firewall rules can be enabled via the WebUI, unlimited firewall configuration via CLI; NAT; NAT-T, Access control Flexible access control of TCP, UDP, ICMP packets, MAC address filter, VPN OpenVPN Multiple clients and a server can run simultaneously, 12 encryption methods, OpenVPN Encryption DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC, IPsec IKEv1, IKEv2, supports up to 5 x VPN IPsec tunnels (instances), with 5 encryption methods (DES, 3DES, AES128, AES192, AES256), GRE GRE tunnel, PPTP, L2TP Client/Server services can run simultaneously, SERIAL COMMUNICATION MODES Modes Console, OverIP, Modem (Full or Partial control) (planned), Modbus RTU master, Modbus gateway, NTRIP client (planned), MODBUS MODBUS TCP SLAVE ID filtering Respond to one ID in range [1;255] or any, Allow remote access Allow access through WAN, Custom registers Modbus TCP custom register block, which allows to read/write to a file inside the router, and can be used to extend Modbus TCP slave functionality, MODBUS TCP MASTER Supported functions 01, 02, 03, 04, 05, 06, 15, 16, Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), MODBUS RTU MASTER Supported baud rates From 300 to 115200, Supported functions 01, 02, 03, 04, 05, 06, 15, 16, Supported data formats 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC), Number of data bits From 5 to 8, Number of stop bits 1 or 2, Parity None, Even, Odd, Flow control None, Xon/Xoff, MODBUS DATA TO SERVER Protocols HTTP(S), MQTT, MONITORING & MANAGEMENT WEB UI HTTP/HTTPS, status, configuration, FW update, CLI, troubleshoot, system log, kernel log, FOTA Firmware update from sever, automatic notification, SSH SSH (v1, v2), SMS SMS status, SMS configuration, MQTT MQTT Broker, MQTT publisher, JSON-RPC Management API over HTTP/HTTPS, Modbus Modbus TCP status/control, RMS Teltonika Remote Management System (RMS), SYSTEM CHARACTERISTICS CPU ARM Cortex-A7 1.2 GHz CPU, RAM 128 MB (50 MB available for userspace), FLASH memory 512 MB (200 MB available for userspace), FIRMWARE / CONFIGURATION WEB UI Update FW from file, check FW on server, configuration profiles, configuration backup, FOTA Update FW/configuration from server, RMS Update FW/configuration for multiple devices, Keep settings Update FW without losing current configuration, FIRMWARE CUSTOMIZATION Operating system RutOS (OpenWrt based Linux OS), Supported languages Busybox shell, Lua, C, C++, Development tools SDK package with build environment provided, INPUT/OUTPUT Configurable I/O 2 x Digital Inputs/Outputs (I/O not available in TRB145*2****), Events SMS status, POWER Connector 4 pin industrial DC power socket, Input voltage range 9 – 30 VDC (4 pin industrial socket), reverse polarity protection, surge protection >33 VDC 10μ max, Power consumption u003C 5 W, PHYSICAL INTERFACES (PORTS, LEDS, ANNTENAS, BUTTONS, SIM) RS485 RS485 interface, Full Duplex (4 wires) and Half Duplex (2 wires), baud rate 300-115200, I/Os 2 Inputs/Outputs pin on 4 pin power connector (I/O not available in TRB145*2****), USB Virtual network interface via USB, Status LEDs 3 x connection type status LEDs, 5 x connection strength LEDs, 1x Power LED, SIM 1 x SIM slot (Mini SIM – 2FF), 1.8 V/3 V, Power 4 pin power connector with 2 x configurable Digital Inputs/Outputs (I/O not available in TRB145*2****), Anntenas 1 x SMA for LTE, Reset Restore factory settings button, PHYSICAL SPECIFICATIONS Casing material Aluminum housing, Dimensions 64.4 x 74.5 x 25 mm (L x W x H), Weight 130 g, Mounting options Bottom and sideways DIN rail, Flat surface and direct PCB on DIN-Rail mounting options, OPERATING ENVIRONMENT Operating temperature -40 °C to 75 °C, Operating humidity 10 % to 90 % non-condensing, Ingress Protection Rating IP30, REGULATORY & TYPE APPROVALS Regulatory CE/RED, EAC, RoHS, WEEE, EMI Standards Draft ETSI EN 301 489-1 V2.2.0, Draft EN 301 489-19 V2.1.0, Draft ETSI EN 301 489-52 V1.1.0, ESD EN 61000-4-2:2009, RS EN 61000-4-3:2006 + A1:2008 + A2:2010, EFT EN 61000-4-4:2012, Surge protection EN 61000-4-5:2014, CS EN 61000-4-6:2014, DIP EN 61000-4-11:2004, RF Standards EN 300 511 V12.5.1, ETSI EN 301 908-1 V11.1.1, ETSI EN 301 908-2 V11.1.2, ETSI EN 301 908-13 V11.1.2, SAFETY Standards IEC 62368-1:2014(Second Edition), EN 62368-1:2014+A11:2017nEN 50385:2017nEN 62232:2017, , TRB145 TELTONIKA